Skip to content

Happy Commercial Grade™

Commercial Grade needs its own order Your cart is reserved for Commercial Grade

Happy Commercial Grade ships separately from the UK and must be ordered on its own. Please complete or empty your current cart first.

Your cart contains Happy Commercial Grade wallpaper, which must be ordered separately. Please complete or empty that order first.

You can empty the cart and add this design right away, or keep the cart and come back to this design later.

View cart
Black Week is here – enjoy 20% off sitewide for a limited time.

Hanging instructions

Preparation

1. Make sure the surface is smooth and clean

Remove any old paint or wallpaper that is coming off. Clean the surface and patch any holes or cracks with spackle. If the surface is porous, please apply a primer or wallpaper sizing before you hang the mural. Porous surfaces include freshly skim-coated walls, walls with old wallpaper, particle board, or similar materials. When hanging on dense, non-porous surfaces, the paste may take several days to dry, as the paper is not very breathable. You should also prime the surface if it is a dark or strong color that could show through the wall mural.

2. Mix wallpaper paste (sold separately)

Fill a clean bucket with 1 gallon (4 liters) of cold water and slowly add the paste powder while stirring briskly. Let the paste stand for 5 minutes, then stir again. The paste is now ready to use. The paste should have a thick consistency, so don't use more than 1 gallon (4 liters) of water when mixing. If you do add more, the wallpaper may not adhere properly. One bag covers about 215-235 sq ft (20-22 m²). If you would rather not mix your own, use a ready-mixed paste rated for non-woven wallpaper.

Hanging

1. Check the wallpaper

Before hanging, make sure no panels are missing and none have any defects or damage. The panels are numbered at the top in the order they should be hung. Hang from left to right.

2. Make sure the panels are hung straight

The first panel must be perfectly plumb. Draw a vertical line one panel width (19.7 in / 50 cm) in from the corner using a level, a tape measure, and a pencil. Use that line as a guide for the first panel. Keep the pencil marks faint so they don't show through the wall mural.

3. Apply the paste directly to the wall

Use a roller or a brush. It's important to cover the whole area with paste, because an unpasted spot will create a blister in the wall mural. Apply the paste approximately one panel width ahead of where you're working.

4. Hang the panels edge to edge

The panels should not overlap. Take care to press the panels together firmly at the seams. A seam roller gives the best results. Be careful to match up the pattern with the next panel, and avoid getting wallpaper paste on the front of the mural as this will show when it dries. Note: Avoid sharp creases as these may cause cracks in the print.

5. Smooth down the panels from ceiling to floor

Use your hands or a wallpaper brush, starting from the middle and smoothing out toward the edges. Any small bubbles and wrinkles will disappear once the wall mural has dried. If there are any spots of paste on the front of the wallpaper, use a damp cloth or sponge to remove them, but avoid rubbing.

6. Trim off any excess paper

Once all the panels have been hung, trim off any excess paper using a trim guide and a sharp knife.

Let it dry

Allow the wallpaper to dry completely, then sit back and enjoy your new room!

  • The panels are numbered in the order they should be hung
  • Hang from left to right
  • The panels should be hung edge to edge

Recommended tools

  • Bucket
  • Roller & tray
  • Brush
  • Wallpaper brush
  • Seam roller
  • Sponge/Cloth
  • Trim guide
  • Utility knife
  • Tape measure
  • Pencil
  • Level